I need to ask for help configuring a PR6-10 on the K3. Installed OK, removed the internal jumper per instructions and am using the control line on a Y splitter to allow the KPA and KAT to connect to the K3 as well. Physically, all seems fine, and the K3, P3, KPA and KAT work just as they always did.
Then to operate the pre-amp I configured digout1 to ³on² for 28 Mhz on the K3, per instructions. OK so far. The PR6-10 manual says ³Tap RX ANT to enable preamplifier.² When I do so the noise level goes way down and the signals disappear, as if there were no antenna connected to the receiver. Removing the power plug from the preamp made no difference in either mode RX ANT on or off. I recall when building the K3 that there were elections to be made about antenna configurations when installing the sub receiver and/or the KXV3. I also remember that there are a myriad of ways the antennas can be routed via the configuration menus. I have a feeling that the elections and internal configurations I originally made in the K3 are not compatible with getting the PR6-10 to work simply by pressing RX ANT, but I can¹t reason my way through it all. Help, anyone? Thanks! Ted, KN1CBR ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
