If CM-500 is connected to rear panel mic jack it works fine, however if it is connected to front panel mic jack via conversion connector I have a very low mic lebel with max mic level setting. If CM-500 is connected to KX3 it works fine.
CM-500 mic plug to 8p plug connection in conversion connector is like this..... tip to pin-1 ring to pin 6 (K3 provides 8V regardless Bias ON/OFF) sleeve to pin 7 I have another electret condenser hand mic. If this mic is connected to K3 front panel mic jack it works fine. If CM-500 is connected to K2 (where 5V is provided to pin 6 of mic jack) using same conversion connector it works fine. Any suggestions please. -- 73 de aki ja1nlx ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
