Hi Urb, Jay is quite correct. The latest K3 Utility Program is here: http://www.elecraft.com/K3/k3_software.htm
- 73 and good DX de Mike, K6MKF, President - NCDXC, IDXC 2015, W6NAG, IDXG, ADXG, RRC #933, K3-P3-KPA500-KAT500 Addict, Maui -----Original Message----- From: Elecraft [mailto:[email protected]] On Behalf Of Jay K2TTT Sent: Monday, September 15, 2014 10:06 AM To: 'Urb LeJeune'; [email protected] Subject: Re: [Elecraft] Newbie questions Urb It is easy: 1.You can reset everything by the following: Power off Hold in shift knob while pressing power on switch unit it fully powers up You will have to start over again just like you had just finished building it - so don't so this just for grins If you have an older configuration file saved you can reload it and be right back where you were when you saved the file. The firmware is not affected either way - kinda like a restore point in Win XP. 2. The K3 utility program available "FREE" on their webste will do all that. I would suggest that once you do a "reset" as above save it with the utility program so you can always undo what you done did 73 K2TTT (Jay)C6ATT ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
