Also, if your K3 was factory built and is not one of the earlier units shipped,
we usually have the original factory config file recorded here. Contact
[email protected] and they can help you out.
Eric
elecraft.com
On 9/15/2014 10:18 AM, Mike Flowers wrote:
Hi Urb,
Jay is quite correct. The latest K3 Utility Program is here:
http://www.elecraft.com/K3/k3_software.htm
- 73 and good DX de Mike, K6MKF, President - NCDXC, IDXC 2015, W6NAG, IDXG,
ADXG, RRC #933, K3-P3-KPA500-KAT500 Addict, Maui
-----Original Message-----
From: Elecraft [mailto:[email protected]] On Behalf Of Jay
K2TTT
Sent: Monday, September 15, 2014 10:06 AM
To: 'Urb LeJeune'; [email protected]
Subject: Re: [Elecraft] Newbie questions
Urb
It is easy:
1.You can reset everything by the following:
Power off
Hold in shift knob while pressing power on switch unit it fully powers
up
You will have to start over again just like you had just finished
building it - so don't so this just for grins
If you have an older configuration file saved you can reload it and be
right back where you were when you saved the file. The firmware
is not affected either way - kinda like a restore point in Win XP.
2. The K3 utility program available "FREE" on their webste will do all
that.
I would suggest that once you do a "reset" as above save it with the
utility program so you can always undo what you done did
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
