On 10/23/2014 3:58 AM, Vic Rosenthal 4X6GP/K2VCO wrote:
I have a BC band filter which is used with the MFJ antenna analyzer
when there are nearby BC signals. Sure enough, putting this in series
with the K3 ANT 1 connector kills the noise. Of course I can't
transmit through it.
Hi Vic,
A few suggestions. First, try the BC Band filter on the K3 RX loop. If
that works, work out a switching arrangement so that you can apply it to
either antenna. Second, build or buy a BCB filter that can handle the K3
output. Based on the frequency of the BCB transmitter, one of the lower
cost filters should work. I've measured the vintage ICE BCB filter, and
it's good for at least 40 dB on 1080.
Another thought is that this might be common mode on the coax, in which
case a serious ferrite choke tuned to 1080 might help. I'd start with at
least 20 turns of RG58 on a #31 2.4-in toroid, and I'd put it by the rig.
73, Jim K9YC
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
