When using KPA500 my external monitor (and the P3 display) often freezes, sometimes up to 5 seconds, after I transmit. With the external display disabled, the P3 does not freeze (and incidentally it refreshes much faster without the ext monitor enabled.) I also notice a slight flickering of the monitor screen while transmitting. I take this to be a RFI problem. I have added four snap on ferrite beads on each end of the VGA cable. The monitor is as far away from the amp and feedlines as I can get it and all equipment K3, P3, KPA500, KAT500 are bonded to a ground bus. This is not unique to this monitor as it happened with a different smaller monitor I used before.
This has always been a problem, and I would like to eliminate it as it is very disruptive to is usefulness in finding a clear spot to break through a pileup. Not sure what else to do. Has anyone else had this issue? ..mike AI6II -- View this message in context: http://elecraft.365791.n2.nabble.com/P3-SVGA-external-monitor-freezes-RFI-tp7594411.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com