Hi Mike Is it a Samsung monitor? And did you put beads on the power line in too? Gerald On Nov 5, 2014 11:33 AM, "mike" <[email protected]> wrote:
> When using KPA500 my external monitor (and the P3 display) often freezes, > sometimes up to 5 seconds, after I transmit. With the external display > disabled, the P3 does not freeze (and incidentally it refreshes much faster > without the ext monitor enabled.) I also notice a slight flickering of the > monitor screen while transmitting. I take this to be a RFI problem. I have > added four snap on ferrite beads on each end of the VGA cable. The monitor > is as far away from the amp and feedlines as I can get it and all equipment > K3, P3, KPA500, KAT500 are bonded to a ground bus. This is not unique to > this monitor as it happened with a different smaller monitor I used before. > > This has always been a problem, and I would like to eliminate it as it is > very disruptive to is usefulness in finding a clear spot to break through a > pileup. Not sure what else to do. Has anyone else had this issue? > > ..mike AI6II > > > > -- > View this message in context: > http://elecraft.365791.n2.nabble.com/P3-SVGA-external-monitor-freezes-RFI-tp7594411.html > Sent from the Elecraft mailing list archive at Nabble.com. > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
