This could happen if the control cable from KX3 to amp were not properly connected. On power-up, the KX3 waits several seconds to see if the amp is responding, and if not, it sets PA MODE to OFF.
Wayne N6KR ---- http://www.elecraft.com > On Nov 7, 2014, at 5:18 PM, George via Elecraft <[email protected]> > wrote: > > I am using KX3 with the KXPA100 Amp. Lately when I turn the KX3 off and > then back on the menu shows PA OFF and I have to reset it to on. Then I also > must turn the power setting back up to 100 watts. Any one else seen this > problem. I have the latest firmware installed. 73 George/W2BPI > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
