>From day one my KX3 has not turned on my KXPA100. I returned the amp to Elecraft and they found nothing wrong with it. It was suggested that I call Elecraft about this. I cannot hear on the phone so I never called. My original menu problem started with the latest firmware. Now I know why. If I just leave the amp switch on then the KX3 menu keeps the PA on. At least now I know what caused the menu problem 73 George/W2BPI _Wayne Burdick_ (http://www.mail-archive.com/[email protected]&q=from:"Wayne+Burdick";) _Fri, 07 Nov 2014 17:59:44 -0800_ (http://www.mail-archive.com/[email protected]&q=date:20141107)
This could happen if the control cable from KX3 to amp were not properly connected. On power-up, the KX3 waits several seconds to see if the amp is responding, and if not, it sets PA MODE to OFF. Wayne N6KR ---- _http://www.elecraft.com_ (http://www.elecraft.com/) > On Nov 7, 2014, at 5:18 PM, George via Elecraft <[email protected]> > wrote: > > I am using KX3 with the KXPA100 Amp. Lately when I turn the KX3 off and > then back on the menu shows PA OFF and I have to reset it to on. Then I also > must turn the power setting back up to 100 watts. Any one else seen this > problem. I have the latest firmware installed. 73 George/W2BPI ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
