Sorry Paul, no answer to your problem with CW (not yet tried).
On my side, I am a bit disappointed with my KX3-2m because of low TX
output (2W instead of 3 announced) and lot of birdies on dummy load in
RX mode. When using an external antenna, noise level increases and some
birdies disappear but not all especially on 144.400 MHz. Do not try to
connect an antenna (flexible quarter wave in my case) directly on SMA
socket, you will receive a lot of birdies so, no way to use my KX3-2m
like I used to do at the end of 70's with my IC-202 transceiver and
telescopic antenna.
Any way to cure my problems?
73's.
Jacques F6AJW/Paris
Le 21/11/2014 18:05, paul hippenmeyer a écrit :
Hi all,
CW on 2m is a problem. Especially with speeds higher than 25 wpm the
timing of the sidetone becomes very unregular (eg. continues keying of
dots only). With an external keyer the problem seems to be even worse.
QRQ CW sounds very dirty.
CW on HF bands is perfect.
Any others who can confirm this problem?
73, paul
hb9axl
MCU 2.25
DSP 1.30
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
