Hello, I tried upgrading the firmware to 4.93 today. I first tried a plain "send all firmware", MCU load went fine and then FPF failed. I restarted the K3 as suggested and at this point FPF was listed as 1.16 and no longer proposed for update. I was able to load DSP firmware after this, by doing a "send all new firmware". Then I turned on advanced mode and tried a couple of times to load FPF again. This is what I get:
09:33:33 Elecraft K3 Utility for Linux Revision 1.13.8.27 09:33:34 K3 MCU revision 04.93. RS-232 speed 38400 bps. 09:33:48 K3 MCU revision 04.93. RS-232 speed 38400 bps. 09:33:51 Erasing Flash Memory 09:33:55 Sending firmware file "hfpf0116.hex" to FPF 09:36:05 Send FPF firmware failed at load addresst 176128 09:53:46 FPF firmware load failed 09:53:47 K3 MCU revision 04.93. RS-232 speed 38400 bps. 09:53:47 Ready A small window suggests to check for firmware correctness, but I don't know where to find this info. Here's the md5 of the file I have: e6b579198d681e380a60a4036063a2cc hfpf0116.hex The radio appears to be working normally (for what I can check not having an antenna other than the 2m one at this time). All front panel buttons and controls seem to do what they're supposed to. What else should I try? Pf -- Pierfrancesco Caci, ik5pvx ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
