Along this same line... I just checked, and I am showing only 4.86 available, just did the get software from Elecraft thing, and I don't see 4.93???
Is there another way of getting software updates for teh rig? -- Thanks and 73's, For equipment, and software setups and reviews see: www.nk7z.net for MixW support see; http://groups.yahoo.com/neo/groups/mixw/info for Dopplergram information see: http://groups.yahoo.com/neo/groups/dopplergram/info for MM-SSTV see: http://groups.yahoo.com/neo/groups/MM-SSTV/info On Sat, 2014-11-29 at 15:12 +0000, David Fleming via Elecraft wrote: > You're using an older version of the utility. Try version 1.14.10.24. You're > probably okay if the K3 is reporting 1.16. > > David, W4SMT > From: Pierfrancesco Caci <[email protected]> > To: [email protected] > Sent: Saturday, November 29, 2014 4:07 AM > Subject: [Elecraft] K3 FPF firmware load failed > > > Hello, > I tried upgrading the firmware to 4.93 today. I first tried a plain > "send all firmware", MCU load went fine and then FPF failed. I restarted > the K3 as suggested and at this point FPF was listed as 1.16 and no > longer proposed for update. I was able to load DSP firmware after this, > by doing a "send all new firmware". > Then I turned on advanced mode and tried a couple of times to load FPF > again. This is what I get: > > > 09:33:33 Elecraft K3 Utility for Linux Revision 1.13.8.27 > 09:33:34 K3 MCU revision 04.93. RS-232 speed 38400 bps. > 09:33:48 K3 MCU revision 04.93. RS-232 speed 38400 bps. > 09:33:51 Erasing Flash Memory > 09:33:55 Sending firmware file "hfpf0116.hex" to FPF > 09:36:05 Send FPF firmware failed at load addresst 176128 > 09:53:46 FPF firmware load failed > 09:53:47 K3 MCU revision 04.93. RS-232 speed 38400 bps. > 09:53:47 Ready > > A small window suggests to check for firmware correctness, but I don't > know where to find this info. Here's the md5 of the file I have: > > e6b579198d681e380a60a4036063a2cc hfpf0116.hex > > The radio appears to be working normally (for what I can check not > having an antenna other than the 2m one at this time). > All front panel buttons and controls seem to do what they're supposed > to. > > What else should I try? > > Pf > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
