Sorry just saw you were running the most recent firmware. Since that's a non-issue (again, apologies for not reading thoroughly enough) question still remains re: power supply/battery unit. My question is - if you can run off a different power source do you see the same behavior?
On Mon, Dec 1, 2014 at 9:07 PM, David Orman <[email protected]> wrote: > I have not run into this. Are you running the most recent stable firmware? > How are you supplying power to your unit? Do you have the battery module > option installed? > > Thanks, > David/K5DJO > > On Mon, Dec 1, 2014 at 8:52 PM, l s via Elecraft <[email protected] > > wrote: > >> Has anyone with a KX3 experienced this problem? When turning the kx3 on >> with theband- and atu tune buttons the back ground leds come on but no >> screen display. Removing the power cable and letting it sit there >> disconnected for a few hours and then when power up is turned on >> everything starts working just fine. This occurs intermittently several >> times a day. >> Have performed the parameter initialization as per the instructions on >> page 46 of the manual and upgraded to the latest firmware version but no >> help.. the problem still exists. Any suggestions short of sending it back >> to Elecraft. S/N 6652. Tnx for reading it.Lou KI6UM >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html >> Message delivered to [email protected] > > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
