Are you using the power cable supplied by Elecraft? If you inadvertently try to use a 2.5mm inner diameter plug on the KX3's 2.1mm pin diameter socket, it will seem to fit but the connection may be poor and may result in strange behaviour.
73, Matt VK2RQ > On 2 Dec 2014, at 1:52 pm, l s via Elecraft <[email protected]> wrote: > > Has anyone with a KX3 experienced this problem? When turning the kx3 on with > theband- and atu tune buttons the back ground leds come on but no screen > display. Removing the power cable and letting it sit there disconnected for a > few hours and then when power up is turned on everything starts working > just fine. This occurs intermittently several times a day. > Have performed the parameter initialization as per the instructions on page > 46 of the manual and upgraded to the latest firmware version but no help.. > the problem still exists. Any suggestions short of sending it back to > Elecraft. S/N 6652. Tnx for reading it.Lou KI6UM > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
