Frank,
Do you have the KSB2 option installed in that K2?
If so, the SSB FL1 filter should be set to "OP1" instead of "2.2".
If you do have the KSB2 option, look at the board. First check the
markings on the crystals
If they are 4913-S you have the new crystals on that board.
Then see if there are capacitors in the CB and CN locations. If not,
the width is the newer 2.4kHz, but if you do not have capacitors there,
you can order the K2SSBCAPKT and change the width to 2.4kHz (or even
2.6kHz if your BFO range is sufficient). You must have the 4913-S
crystals installed to take advantage of that increased filter width.
New KSB2 options come with capacitors for the 2.4kHz width.
73,
Don W3FPR
On 12/6/2014 9:09 PM, Frank Krozel wrote:
OK, pondering this after listening on the K2 to SSB tonight…. Has anyone tried
to align the SSB module to get something more then 2.2kHz?
I was thinking of 2.4, 2.0, 1.7 as my filters when I get the SSB module.
Frank KG9H
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
