I tried with the SVGA disabled and it did NOT occur -- at least in a few
minutes of testing. I suspect the same symptom might result from
multiple causes.
Since Wayne has indicated that it is on their list, I will present my
test parameters and leave it alone from here on. I am sure that they
will get to it:
----------------------------------------------
Problem: display on P3 and SVGA stalls for extended time when returning
to receive from transmit.
Frequency: from once every 3 transitions to once every 10 transitions.
Duration: usually about one second, sometimes longer.
Setup: K3 and P3 with SVGA. No programs running on PC that access K3, no
KPA500 or KAT500. Nothing else connected to K3 aux or RS232 connectors
(except digout1 to PR6-10). KRX3 installed, DVR not installed.
P3 in FIXED or TRACKING mode.
Firmware: K3: 5.01/2.83/1.16. P3: 1.29. SVGA: 1.16.
Operating parameters: CW QSK, TX TEST, KRX3 on or off, SVGA enabled,
RS232 speed 38400, P3 refresh rate 10ms (changing between 0 and 100
doesn't matter).
Test procedure: send groups of 3 V's at 25 wpm and observe P3 or SVGA
display.
Notes: some people have seen this without SVGA. When I disable SVGA, the
problem goes away.
--
73,
Vic, 4X6GP/K2VCO
Rehovot, Israel
http://www.qsl.net/k2vco/
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
