Bob,
The KAT3 should be no problem to install, just follow the instructions.
For the filter change/addition, again follow the instructions. If there
is no KRX3 option installed, it is simply a matter of removing the top
and bottom covers, but if the KRX3 is installed, it must be removed to
gain access to the filter slots on the main RF board - not difficult,
but it takes a bit longer to remove the KRX3.
73,
Don W3FPR
On 1/12/2015 8:19 PM, Bob Gibson via Elecraft wrote:
HI All..I just bought a used K-3, I wanted to install the antenna tuner and
2.8 SSB filter as well as the 6 KC SSB filter.. I have never looked inside the
K-3 so..is this going to be a hard job to do?Bob W5RG Almost 60 years in Ham
Radio
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
