1. Make sure CONFIG:KPA3 shows 'PA nor'. If not, set it to 'PA nor'. 2. If 1. doesn't work or doesn't apply, contact [email protected].
73, matt W6NIA On Tue, 13 Jan 2015 10:59:19 -0500, you wrote: >Prior to running WSPR on 10 meters at 5 watts for about 30 minutes >yesterday the radio was functioning properly putting around 30 watts into a >KPA500. Now today nothing above 12. I've tried the parameter >initialization, power calibration, and even reloading the firmware but no >joy. Is there anything else I could try or should I ship it to Elecraft? >Thanks, Reed AA1RB >______________________________________________________________ >Elecraft mailing list >Home: http://mailman.qth.net/mailman/listinfo/elecraft >Help: http://mailman.qth.net/mmfaq.htm >Post: mailto:[email protected] > >This list hosted by: http://www.qsl.net >Please help support this email list: http://www.qsl.net/donate.html >Message delivered to [email protected] Matt Zilmer, W6NIA -- "Give me six hours to chop down a tree and I will spend the first four sharpening the axe." -A. Lincoln ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
