RX Shift is definitely set to 8.0, on every band. I had to do that for the previous step, which went successfully.
Thank you, David On Mon, Feb 16, 2015 at 3:36 AM, Matt VK2RQ <[email protected]> wrote: > I'd say you have RX SHFT set to "nor" instead of "8.0". If you set your > sidetone to 550Hz, and 8kHz shift is not enabled, then you'll pick up the > image 2 * 550 Hz = 1.1 kHz away, which is what you are reporting. > > Remember that RX SHFT is a "per-band" setting, so you need to enable it > separately for each band. > > 73, > Matt VK2RQ > > > On 16 Feb 2015, at 12:17 pm, David Orman <[email protected]> wrote: > > > > Hi, > > > > I've been performing all of the "All-Band Receive Opposite Sideband and > > I.F. Image Nulling" steps without issue using my PX3 (and AA-54) as a > > signal generator. I'm at the last section, "RX SHFT=8.0 I.F. Image (16 > kHz) > > Nulling", and am having trouble. Following the directions, and setting my > > KX3 16KHz up from the signal source: > > > > 7. Optimize RX SHFT=8.0 I.F. image gain and phase settings as follows: a. > > Set both the signal source and KX3 to the target band (starting with 160 > > m). Recall that the VFO should be set 16 kHz higher than the signal > source. > > Make sure you’re in CW mode. (Note: You can change bands and modes from > > within the RXSBNUL menu entry.) You should hear a strong signal, and see > an > > Smeter reading of between S9 and S9+30 dB. If not, adjust the preamp > > setting or the RF source level. > > > > This step, I do _not_ hear a strong signal, I hear no signal at all. If I > > turn on RIT to -1.1, I hear a strong signal (looking at the next step.) > > > > What am I doing wrong/missing? > > > > Thank you, > > David > > ______________________________________________________________ > > Elecraft mailing list > > Home: http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/mmfaq.htm > > Post: mailto:[email protected] > > > > This list hosted by: http://www.qsl.net > > Please help support this email list: http://www.qsl.net/donate.html > > Message delivered to [email protected] > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
