You need the updated Synth board and the general
coverage filter option in your K3.
Phil W7OX
On 2/22/15 11:45 AM, Chris Hallinan wrote:
OK, I'll ask the "stupid" question. What is a "syn pwa" and how do I
get on 630M with K3? (Guessing the answers are related!) I'll skip
asking what WSPR mean...I looked it up and found answers.
-Chris
K1AY
On Sun, Feb 22, 2015 at 2:56 PM, Ken Roberson via Elecraft
<[email protected]> wrote:
Hello all,
Installed the syn pwa yesterday and ran 630M WSPR beacon overnight.I should be
getting 1mw out of the K3 - however I,m only getting .8 mw.Today I will run the
power cal maybe that will help to get a little morepower out.
The K3 is preforming very nice on 630 meters.set your rx dial to 474.2 - upper
side band .On 630 meters I,m running 5 watts ERP into a 60 ft top loaded
vertical.Check out the WSPR map around 8:PM to10:PM
There are a few photo and a little info on qrz-dot-com.Thanks everyone
73 Ken K5DNL/WG2XXM
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
