Ah right. I did follow the thread after the announcement about the new KSYN3A, just didn't quite sink in. Alphabet soup still has me guessing sometimes ;)
Thanks all! -Chris On Sun, Feb 22, 2015 at 9:20 PM, Phil Wheeler <[email protected]> wrote: > You need the updated Synth board and the general coverage filter option in > your K3. > > Phil W7OX > > > On 2/22/15 11:45 AM, Chris Hallinan wrote: >> >> OK, I'll ask the "stupid" question. What is a "syn pwa" and how do I >> get on 630M with K3? (Guessing the answers are related!) I'll skip >> asking what WSPR mean...I looked it up and found answers. >> >> -Chris >> K1AY >> >> On Sun, Feb 22, 2015 at 2:56 PM, Ken Roberson via Elecraft >> <[email protected]> wrote: >>> >>> Hello all, >>> Installed the syn pwa yesterday and ran 630M WSPR beacon overnight.I >>> should be getting 1mw out of the K3 - however I,m only getting .8 mw.Today I >>> will run the power cal maybe that will help to get a little morepower out. >>> The K3 is preforming very nice on 630 meters.set your rx dial to 474.2 - >>> upper side band .On 630 meters I,m running 5 watts ERP into a 60 ft top >>> loaded vertical.Check out the WSPR map around 8:PM to10:PM >>> There are a few photo and a little info on qrz-dot-com.Thanks everyone >>> 73 Ken K5DNL/WG2XXM > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] -- Life is like Linux - it never stands still. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
