David, you may be correct, so I will repost to the list what I sent to Mike earlier today. It did not entirely correct his problem, however.
Mike, I'm pretty new to digital, but am using Fldigi, so I'll give it a shot. In Windows, I right-clicked on the speaker icon in the lower right corner, then selected Sounds. On the Playback tab, I selected Speakers set to my USB Audio CODEC; likewise, on the Recording tab, Microphone is also set to my USB Audio CODEC. In Fldigi, in Config\Soundcard (I'm using an audio interface: Tascam US-100), I set Audio\Devices by checking PortAudio, then selecting the Microphone (under Capture) and Speakers (under Playback) that my sound card is set to in Windows sound - USB Audio CODEC. Next, in Fldigi in Config\Rig control, choose the Rig tab, then Hamlib. In Hamlib, check the box in front of Use Hamlib at the top. In Rig choose Elecraft K3/KX3 (Beta). In Device, choose your com port. Below that, set the Baud rate to 38400. On the left side, check the box for PTT via Hamlib command. Finally, click Save at the bottom, then Close. Hope that helps and works for your set up. 73, Dave W8OV On 2/24/2015 6:16 PM, David Christ wrote: > But that’s a problem of probable general interest and the results should end > up in the archives. > > DavidK0LUM > > > On Feb 24, 2015, at 12:09 PM, Mike Reublin NF4L <[email protected]> wrote: > >> I've been using CocoaModem, but since Chen isn't supporting it anymore, I >> feel the need to move on. >> >> I'm trying to get fldigi working, hopefully with RUMLogNG. >> >> It decodes CW but not RTTY, and doesn't transmit either. I suspect off-line >> would be best. >> >> 73, Mike NF4L >> ______________________________________________________________ > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
