Hi Rick,
I have had similar types of issues and found with the help of Elecraft
Support that the problem was the seating of the AUXBUS cables. Mine
would seat one side or the other but not both. I used a knife to par off
a little notch in the cable housing to allow it to fit over the
retaining nut. I even tried to line the nuts up so the sides were
vertical but this didn't work.
Hope you find the problem soon its a great system when all working together.
73 de Tony G6GLP
On 16/03/2015 18:02, Rick Stanback wrote:
I just completed the build of my KAT500 and KPA500 and I had the
following issues.
The KAT500:
the software was very flaky trying to connect to the KAT. I run Fedora
21 so it might be the bleeding edge Linux. I did finally get the
connect and hit the optimize for KPA500 button. I am still not able to
hit the tune button on the KAT500 and get the K3 to xmit and tune. If I
hit the button and then hit the tune button manually on the K3 it tunes?
KPA500:
When I first powered up the display would say KPA500 for a bit then
Invalid?? Then if I put the amp to oper it would immediately get the
270v fault. I took it apart and inspected all the connections including
the ribbon cables and although I did not find anything out of place or
not seated when I put it back together it seems to just work? I have
made a few contacts and everything seems to be OK. The amp follows the
K3 band with no problems.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
