The new KSYN3a does not need the synth cal step. As noted in the manual, that only applies to the older synthesizer.
73, Eric elecraft.com _..._ > On Mar 22, 2015, at 7:39 AM, Klaus Dittrich <[email protected]> wrote: > > K3 SN 8887 > > MCU 5.14 / DSP 2.83 / FPF 1.19, 2/26/2015 > Latest Production Release > > I still see CONFIG: VCO:MD -- and calibration started (digits count uwards) > after leaving the menu but ends with an error after some time. > > > I assume this can be ignored, as the KSYN3A does not need calibration? > > Or is the KSYN3A not recognized by the firmware? > > -- > > 73, Klaus, DF1TL > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
