Display now reads E00.7 i0.06 and low batt following my poking around inside. Following guidance in the archives I measured (RX mode — TX display readings of swr, pwr seem ok)
D10 anode 13.89, cathode 13.69 volts Pins 2 and 3 of xxx 13.65 and 13.65 R9 voltages 13.67 and 2.62 R8 voltages 13.65 and 13.65 U3 voltages (1) 13.57 transitioning to 0 after 1 sec; (2) 13.65; (3) 13.61 transitioning to 0; (4) 0; (5) 2.61; (6)2.66; (7)2.66; (8) 13.61 U6 pin 5 2.66V Probing for suggestions for what to measure next (or advice to go ahead and replace U3 and/or U6 or something else) Tnx for any help, Karl W3BF ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
