FWIW, I just found a 2mm long piece of wire clipped from a
component lead shorting my current project. Look carefully.
73 Bill AE6JV
On 3/26/15 at 3:16 PM, [email protected] (Don Wilhelm) wrote:
You did not say what your "poking around inside" consisted of.
If you induced static charge on some of the pins of U6 that
could be the cause - OTOH, if you were soldering, look for
solder in places where it should not be (solder bridge).
-------------------------------------------------------------------------
Bill Frantz | Re: Hardware Management Modes: | Periwinkle
(408)356-8506 | If there's a mode, there's a | 16345
Englewood Ave
www.pwpconsult.com | failure mode. - Jerry Leichter | Los Gatos,
CA 95032
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
