Ken,
Actually, since you have the P3 in place too, there are 5 possible
points of failure instead of 3. To what I mentioned before, add the P3
RS-232 'thru' path, and the RS-232 cable between the P3 and the K3.
Eliminate the P3 and the P3 to K3 cable by connecting the RS-232 cable
directly to the K3.
73,
Don W3FPR
----------------------------------------------------------
Ken,
Since the K3 is "doing its thing" normally, try another USB to serial
adapter, or another computer.
There are 3 possible things that could be at fault - the computer, the
USB to serial adapter, or the K3 RS-232 interface.
Do what you can to reduce the possible points of failure down to one.
73,
Don W3FPR
On 3/29/2015 9:30 AM, K M Dailey wrote:
Hi Ross,
Yup, tried that - powered the K3 off, waited 30 secs, powered on and held the
Power button down until the red TX light comes on and MCU LD appears - still no
comms to the iMac.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
