Joe,
As I was told, they ship it with the pad at the input to meet FCC
requirement of max 15db gain. But the pad can be easily bypassed. Just
wonder, what is the reason for such a requirement?
73, Igor UA9CDC
----- Original Message -----
From: "Joe Subich, W4TV" <[email protected]>
To: <[email protected]>
Sent: Friday, April 03, 2015 7:48 AM
Subject: Re: [Elecraft] Question K3 ALC w/SPE Expert 1.3K-FA amp
This is because the software in the amp automatically reduces the
power in the rig to the best output level for the amp (on the amp
LOW=500W out= 3W drive, MID= 1000W out= 6W drive, HIGH = 1500W out =
9W drive). It works flawlessly. Actually, I could leave the power on
the Pro III untouched, and the amp reduces the power accordingly.
Is SPE shipping amplifiers that violate type acceptance or did you
modify that amplifier? Any commercial amplifier sold in the US can
have a maximum gain of 15 dB. Your Expert 1.3K-FA shows 22 dB -
nearly 6 dB above the limit.
73,
... Joe, W4TV
On 2015-04-02 10:34 PM, AB2E Darrell wrote:
Hello all,
I am the proud new owner of a new K3. I am also the proud new
owner of an SPE Expert 1.3K-FA solid state amp, and I have a question for
the group regarding interfacing the K3 to the amp.
My current setup is using my Icom 756 Pro III with the SPE Expert
1.3K-FA. The recommended setup for Icom was to connect both the Relay and
ALC cables between the rig and amp. This is because the software in the
amp automatically reduces the power in the rig to the best output level
for the amp (on the amp LOW=500W out= 3W drive, MID= 1000W out= 6W drive,
HIGH = 1500W out = 9W drive). It works flawlessly. Actually, I could
leave the power on the Pro III untouched, and the amp reduces the power
accordingly.
My question for the group is, is there a way to allow the K3's output to
be controlled by the amp? I see the note on p27 about not using an amp to
control the K3's output, but wonder if there is a safe way to do it. For
instance, could the K3 be set to say 15W out on all bands via the menu,
then allow the amp to control the output via ALC for optimum drive?
Any info and comments appreciated.
73 Darrell AB2E
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
