Hi Chris, You probably turned on CW QRQ mode. See CONFIG:CW QRQ.
73, Wayne N6KR On Apr 3, 2015, at 3:34 PM, Chris Hallinan <[email protected]> wrote: > Hi folks, > > Somehow I managed to get my K3 into some state where the shift function > doesn't shift, and I'm unable to select the alternate functions of the > shift and width knobs to hi/lo cut. > > Mode CW, VFO-A, nothing unusual. LEDs show Shift and Width functions > enabled. > > When I rotate Shift, the vfo-b display simply shows FC *0.48 (my pitch, the > center of the passband.) It does not shift. Width control works. I've > power cycled, still no joy. No software connected, either. Pressing each > button does nothing. (Should go to alternate mode, ie lo/hi cut. Long > pressing shift does normalize. It's only the functions associated with the > shift knob. > > What gives? What did I do wrong? > > Chris > K1AY > > -- > Life is like Linux - it never stands still. > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
