Yes, that was the issue. Thanks, Wayne and all! Still getting to know my new K3!
73, Chris - K1AY On Fri, Apr 3, 2015 at 8:27 PM, Wayne Burdick <[email protected]> wrote: > Hi Chris, > > You probably turned on CW QRQ mode. See CONFIG:CW QRQ. > > 73, > Wayne > N6KR > > On Apr 3, 2015, at 3:34 PM, Chris Hallinan <[email protected]> wrote: > > > Hi folks, > > > > Somehow I managed to get my K3 into some state where the shift function > > doesn't shift, and I'm unable to select the alternate functions of the > > shift and width knobs to hi/lo cut. > > > > Mode CW, VFO-A, nothing unusual. LEDs show Shift and Width functions > > enabled. > > > > When I rotate Shift, the vfo-b display simply shows FC *0.48 (my pitch, > the > > center of the passband.) It does not shift. Width control works. I've > > power cycled, still no joy. No software connected, either. Pressing each > > button does nothing. (Should go to alternate mode, ie lo/hi cut. Long > > pressing shift does normalize. It's only the functions associated with > the > > shift knob. > > > > What gives? What did I do wrong? > > > > Chris > > K1AY > > > > -- > > Life is like Linux - it never stands still. > > ______________________________________________________________ > > Elecraft mailing list > > Home: http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/mmfaq.htm > > Post: mailto:[email protected] > > > > This list hosted by: http://www.qsl.net > > Please help support this email list: http://www.qsl.net/donate.html > > Message delivered to [email protected] > > -- Life is like Linux - it never stands still. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
