See below - > On Thursday, Jun 25, 2015, at Thursday, 1:57 PM, Mike Reublin NF4L > <[email protected]> wrote: > > Jim - > > I have a K3 and P3, and am assuming that the cabling is the same for the Xs, > cable from computer to PX3, then from PX3 to KX3. Are you using a Mac? If you > use a VM, does that grab the com port? Yes, I'm using an iMac, and yes, they daisy chain just like the K3/P3. I have VMware shut down. I went so far as to unplug the Serial-USB cable going into the iMac and plugged back in. The iMac asked where to connect it to. I told it the Mac. Still no joy. The KX3 by itself connects fine, the PX3 is out to lunch. > > Some shots in the dark. > > Un daisy-chain the KX3 and PX3 and see if the KX3 utility can talk to the KX3 > alone, then check if the PX3 utility can talk to the PX3. If the KX# works > and the PX3 doesn't then the problem is with the PX3 or the cable from the > PX3 to KX3. I unchained 'em and got the same result - iMac cannot see the PX3.
> If you have a different serial cable, try that. Tried using the cable that my K3/P3 use - no joy there, either. > > How about a power-on reset of the PX3? Brought up the PX3 menu to power-on/reset. Again, no change. > > 73, Mike NF4L I called Elecraft - all lines busy. So I sent an email to support. Still waiting for a reply...... > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
