Don, I changed the setting to "Y," and it instantly jumped back on frequency and everything is fine again. As always, I really appreciate your expert and responsive help.
Dick, K0KK On Mon, Jun 29, 2015 at 12:13 PM, Don Wilhelm <[email protected]> wrote: > Dick, > > With the K60XV installed, do your have the menu for d10 set to "Y" - i > needs to be that way or CAL PLL will fail as you stated. > The initial frequency for CAL PLL is in the 12,960 to 12.990 range. > > Your TP1 reading also says that the frequency the K2 is trying to tune to > is near 6350 kHz - again the problem is the d19 menu parameter. > > 73, > Don W3FPR > > > On 6/29/2015 11:46 AM, Dick Lamb wrote: > >> On a K2, the freq display is way, way off; e.g., on 40 meters it's really >> receiving about 0.5 mHz lower. I tried to run CAL PLL but get INFO 232. >> The PLL process appears to start, momentarily displaying 11,27164 mHZ, >> then aborts in about a second with the INFO 232 error. I'm absolutely >> positive before running PLL that the VFO shows a 40 meter freq and the >> probe is plugged into TP1. >> >> The CAL FCTR readings for the TPs are: TP1 = 11271.8(4); TP2 = 4913.55; >> TP3 = 12097.9(6) (Numbers in parentheses flicker between an adjacent >> digit, but values are otherwise stable). >> >> Probably not relevant, but more background. This is my friends K2 for >> which the KPA100 would not work. I traced problem to blown diode in swr >> bridge, fixed it, and that problem was solved. Also, I Initially I made a >> change in the set-up menu for the k60xv, not realizing it was installed. >> Nothing else was touched--at least intentionally. >> >> >> > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
