> Any other ideas?? Are you using MODE=DATA and data sub-mode=DATA_A?
> MIC SEL was set to Line In I changed it to FP > > MIC+LIN was set to NA and I set it ON and the MIC level is set to 60. Set MIC+LIN back to OFF, set Mic SEL back to Line In, place DM780 in PSK31 transmit and adjust the Mic Gain (actually Line Gain in DATA_A) for four bars of ALC with the fifth just flickering then adjust PWR Out for no more than 50W. 73, ... Joe, W4TV On 8/8/2015 8:43 AM, Larry Snyder wrote:
I have my K3 connected to the PC and the K3 software works fine. I have 2 audio cables between Line IN and Line Out of the K3 to the Mic and Speakers on the PC. With HRD - I see the QSOs on the screen and of course the waterfall display at the bottom with an Audio level of 10%. When I attempt to call CQ - The K3 goes into transmit but there is no power coming out of the radio. MIC SEL was set to Line In I changed it to FP MIC+LIN was set to NA and I set it ON and the MIC level is set to 60. Still no difference. Any other ideas?? Sincerely Larry -- Larry Snyder, RN.ORG, SA - HK2LS "Each and Every Day Thousands of Nurses Depend on www.RN.org <http://www.rn.org/> for their Nursing CEUs!"
______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
