Thank you for your reply Matt. I changed the MIC to the back mono mic input and the HRD works fine.
Now getting back to the Line In On the radio in the middle of the right side of the display I see TX DATA I set the DATA mode to DATA A I transmit and adjusted the MIC GAIN and see the DATA level increase on the LCD And bingo, it works just fine. Thank you so very much!! Sincerely Larry -- Larry Snyder, RN.ORG, SA - HK2LS "Each and Every Day Thousands of Nurses Depend on www.RN.org for their Nursing CEUs!" Sent via Dell Server/Retiro -----Original Message----- From: Matt Zilmer [mailto:[email protected]] Sent: Saturday, August 8, 2015 10:28 AM To: [email protected] Cc: [email protected] Subject: Re: [Elecraft] HRD and K3 <snip> > >The K3 goes into transmit but there is no power coming out of the radio. > Problem areas to look for - 1. The K3 mode should be TX DATA (seen on the graphic), and its data mode should be DATA A. DATA A is used to interface external sound to the K3 through line in and out jacks. 2. Line in and out need to go to the sound unit you intend to use on the PC. MIC SEL at the K3 should be set to Line In. 3. HRD needs to be configured to use the sound unit above. Once you've juggled these around to get *some power* out of the K3 on TX, then you should set the K3's LIne In gain (via the MIC control while in TX to a reasonable level). For the K3, use the ALC metering to set 4-5 bars of ALC indicated. This is the correct drive level to use. You may need to adjust both the K3's Line In gain AND the sound unit's Playback level to get a happy medium. Once you've got it, write it down in case something gets moved around. 73, matt W6NIA Matt Zilmer, W6NIA -- "Always store beer in a dark place." -R. Heinlein ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
