There is a recovery procedure in K3 Utility Help. See Troubleshooting, MCU Load.
73 de Dick, K6KR > On Aug 21, 2015, at 00:37, pastor...@verizon.net wrote: > > I am sending this message again, as it seems my first message never made it > to the board. I was trying to load the new Firmware into my K3. Well for some > reason we had a power blip during a storm and now my K3 is stuck in MCU LD. > Right now the screen in dark when power is applied and MCU LD is on the > screen. The Red TX light is flashing and after a period of time it will then > go to the Delta F light which will flash yellow. I cannot connect to my K3 > via my computer because I'm sure it's because it is stuck in the MCU LD > error. How does one reset their K3. I read about the EE Init where I Held in > the Shift/Lo button while pressing the Power button and nothing Plus to get > the K3 out of this state I need to shut off the power supply. Every button is > totally useless. Perhaps I need to call the people at Elecraft once I get > home from work this afternoon. Hopefully someone on the board will have a > solution or someone from elecraft will see this message and help! Thanks! > Mark Gri ff > in, KB3Z > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to d...@elecraft.com ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com