Tony,
Be aware that you must have enough audio to fully illuminate 4 bars on
the ALC meter with the 5th bar flickering.
If you do not have that condition, manipulate the soundcard audio and
the Line In level on the K3S to obtain that deflection.
Maintain that audio level, and adjust the power with the K3S power
knob. This is different than the conventional internet advice which
says set the power to a high value and adjust the audio to get the
desired power output - that will not work with the K3S (or the K3 or KX3
or K2).
If you are using the audio provided by the USB cable, be certain there
is nothing plugged into the K3S Line In jack.
I cannot provide any more information until you clarify more about your
cabling setup - specifically, which is connected to what.
73,
Don W3FPR
On 8/26/2015 8:56 AM, MM6TGN wrote:
I have recently purchased and built my K3S. 100w with ATU.
As an MM6 foundation licence holder, this is my first radio and I am limited
to 10w.
I am a Mac user not a Mac Genius and use a mid 2010 Imac.
I have installed and am successfully using Maclogger.
After discussion with club mates I decided to try Digital modes and was
advised to start with PSK.
After some research I discovered FLdigi installed the programme and the FTDI
driver for the USB and it appears to work well in all respects including rig
control, apart for the fact that the Radio does not appear to transmit.
When I try and answer a CQ by answering call. The waterfall indicates I am
sending data and the message transfers from the bottom to the Top sections
of FLdigi. However there is no indication on the radio that there is any
output. I have had no response to any CQ or answered call.
I think the issue may be with the audio setup.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
