In a word: I can’t. OK, that’s two words. I have followed the procedure and am using the PX3s calibration signal as the signal source. I have recorded the initial Amplitude and Phase settings. I can see the two sideband peaks on the display and watch them move closer and further from the centre of the display as I change frequency. However, no amount of adjusting the phase of amplitude settings will cause the opposite sideband to change whatsoever. I am open to suggestions.
One other point. There’s no mention that I can find in the nulling procedure that says what MODE I should be in. If the opposite sideband is on the right of the display then shouldn’t I be in LSB? If it doesn’t matter for this procedure then that would have been useful information too. Any ideas or assistance would be gratefully received! Thanks and 73, Ken Alexander VE3HLS ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
