Don, Of course it wouldn't in RX. Excuse me. I was under the impression that the OP was referring to TX and the TX "audio", so I'll stand on my comment. Just trying to help sort it out. The OP didn't specifically state RX or TX so how do you *really* know?
Warren On 8/29/2015 4:35 PM, Don Wilhelm wrote: > Warren, > > His problem was in receive, not transmit. So I don't understand how the > drive level setting could have anything to do with it. > > 73, > Don W3FPR > > On 8/29/2015 3:52 PM, Warren Merkel wrote: >> Jim, >> >> Did you check what the K3S power level displays when the KPA500 is in >> Operate mode? It could be set for very low drive. I have mine set up to >> lower the drive from 100w to 30w when the KPA500 goes from standby to >> operate. If you have the setting for per band mode enabled, you will >> need to check it on each band. >> >> Warren, KD4Z >> >> >> On 8/29/2015 12:06 PM, jim rogers wrote: >>> Good morning, >>> >>> I have a new K3S, serial # 10195. All was going well until I hooked up >>> my KPA500 to the K3S using the Elecraft supplied aux cable (E850463). >>> >>> In standby mode (on the KPA500) the audio level on the K3S is nice and >>> loud, BUT when I press the OPER button on the KPA500 the audio level on >>> the K3S all but disappears! >>> >>> If I then press STBY on the KPA500, the audio level on the K3S returns >>> to loud. Only the E850463 cable connects between the two Elecraft >>> components. >>> >>> The KPA500 is about 1 year old and has performed flawlessly to date. Do >>> I have a Firmware issue with the "older" KPA500 and the brand new K3S? >>> >>> Thank you for any suggestion on how to resolve this issue. >>> >>> Jim N4DU >>> >>> >>> >>> >>> ______________________________________________________________ >>> Elecraft mailing list >>> Home: http://mailman.qth.net/mailman/listinfo/elecraft >>> Help: http://mailman.qth.net/mmfaq.htm >>> Post: mailto:[email protected] >>> >>> This list hosted by: http://www.qsl.net >>> Please help support this email list: http://www.qsl.net/donate.html >>> Message delivered to [email protected] >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html >> Message delivered to [email protected] >> > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
