I just received my new K2, SSB and 160M options too. I've also ordered the rework eliminator kit. I've redlined my insructions with errata and rework updates. Assembly starts tonight.
I've hunted around for a general advice thread, but there is so much information out there I can't seem to sift out what I'm looking for. I know the hot end of a soldering iron from the cold end, and I have some test quipment including scope and signal generator. If anyone out there has adice or can point me to the right place, please reply. In particular, if anyone has experience with the rework eliminator please reply. I'm concerned that the test and alignment procedure may not work as it should with these mods. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
