When building my K2 I found it helpful to look at photos of other K2's if I was confused about a part. I couldn't always find exactly the view I was looking for, so I took my own page-by-page photos of my K2 being built. Go to www.craigr.com/coppermine and select the Ham Radio, 2005 category. You'll find the K2 pictures in there.
Have fun! Craig NZ0R K1 #1966 K2/100 #4941 -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of [EMAIL PROTECTED] Sent: Friday, January 27, 2006 12:05 PM To: [email protected] Subject: [Elecraft] Newbie requests advice I just received my new K2, SSB and 160M options too. I've also ordered the rework eliminator kit. I've redlined my insructions with errata and rework updates. Assembly starts tonight. I've hunted around for a general advice thread, but there is so much information out there I can't seem to sift out what I'm looking for. I know the hot end of a soldering iron from the cold end, and I have some test quipment including scope and signal generator. If anyone out there has adice or can point me to the right place, please reply. In particular, if anyone has experience with the rework eliminator please reply. I'm concerned that the test and alignment procedure may not work as it should with these mods. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
