Al,
That sounds like the switch to Weaver demodulation below 1.8 kHz is
causing the 'hole' in your waterfall - that is used for SSB voice reception.
Use DATA A (or AFSK A for RTTY) instead of SSB to avoid that condition.
73,
Don W3FPR
On 9/3/2015 10:55 AM, Al Duncan wrote:
I have RX xFIL set to "normal" in the menu so that the PBT control adjusts
bandwidth. When I use a BW of 1.8 KHz or higher in SSB mode, everything
looks good on a waterfall display. But when I reduce the BW to 1.7 KHz or
lower, a chunk approximately 250 Hz wide and centered at 1500 Hz is removed
from the waterfall display. I originally thought it was related to the
roofing filters as the effect happened at the same time that FL2 was
selected, but after I set the roofing filters to "not installed" so that FL1
was used for all bandwidths, the problems still occurs. Any suggestions
would be appreciated.
KX3-K serial #1691 with latest production release firmware installed. The
roofing filter option was ordered with the transceiver.
73, AL - VE3RRD
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
