Hello Elecraft folk:
Just installed my new P3 TX Monitor board that I ordered at Dayton (!). I have been waiting for this capability for the P3 since 2010, so as to enable me to monitor transmitter waveforms accurately like I did in my Heath SB-401/SB303 station with the SB610 in ancient times (the late '70's). So now my O'Scope can go back to the bench where it belongs. Since I already had an accurate dual meter peak reading Wattmeter (Autek WM-1), the bundled SWR/Wattmeter capability is not important to me. A good, full featured visual transmitted waveform monitor was what I was looking for. However, a big feature is missing from the TX Monitor option: Accurate monitoring of the direct FSK signal for RTTY. All that is visible on RTTY transmissions is a solid envelope that fills the screen, just like sampling RF using my bench 'scope. True, RTTY is a full carrier FM signal, so the display is showing me the "correct" interpretation for an envelope sampler, but I was hoping to at least see the same display we see on RTTY receive: Two pulses with a valley in between. If both pulses are equal, there is no passband ripple. If there are single peaks and the fall to the valley is smooth and sinusoidal, all is well and the transmitter is not being overdriven. My preference, however, would be to see a traditional crossed ellipsis display like on my old SB610 and the simulated one on software RTTY apps (that are NOT real transmitted waveforms!), but I can live with the above. Neither mode is available on the simple envelope sampler add on that comprises the TX Monitor today. I don't use AM here, but the a "Trapezoid" display would also be helpful to set amplifier linearity and peak modulation. These features would make a P3 with the TX Mon option a real, full featured, transmission monitor, which was my assumption that it was to be. Right now, it's a simple envelope sampler which, while helpful (and cute to show off to guests), doesn't do what a true full featured transmission monitoring tool *should* do, especially for RTTY and AM, and especially for its price. I can do most of what it does with a chunk of wire and any o'scope. Am I out of line with my expectation? Are these features in the works for a future software update? If not, they should be! Lu Romero - W4LT K-Line ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
