I think your question is really related to the CW decode function rather
than using the K3 on CW.
I am probably 90% CW, ~3% SSB [Sweepstakes, NAQP's, and RAC's], and the
rest RTTY. This is probably going to touch off a storm on the list, but
here goes:
I run the RF gain full clockwise, always, I don't even know if the knob
moves, never tried, never understood the "ride the RF gain argument."
The K3's AGC is superb and far better than anything I can do.
Admittedly, it is highly tailorable [maybe a tad too many settings], but
once I got it where I liked it, I haven't touched it in several years
[S/N 642 here]. True even when I had KF6T running 1.5 KW 1.7 km from
me. I have the "stock" 2.7 KHz [I think] and a 500 Hz roofing filters.
I could cuddle up to within 1 KHz of Jack and not hear him.
Preamp is on for 21 MHz and above, off below. Attenuator is off for 7
MHz and above, on for 5, 3.5, and 1.8 MHz. That configuration depends
some on your ambient noise levels, mine were moderate until we just
moved, now they're fairly low.
I copy CW the old fashioned way, but I have tried the decoder out of
curiosity. Does well on moderately good signals with reasonable sending
habits. A SNR of about 4 S-units seems to work fine. Gets a little
sketchy with occasional errors [usually in key up periods] below that,
and pretty much fails if the SNR is around 1 S-unit or less. I can
still copy the signal fine at those levels. I can't remember what I
used for THRESHOLD, but as I remember at one number nothing decoded and
at the next one it decoded fine.
The horizontal scroll did tend to cage my eyeballs after a bit. :-)
My K3 was essentially fully operational right after assembly, using all
the default settings. I set up my TX EQ using advice from K9YC, and I
often get unsolicited "great audio" comments in the 3% SSB time. I lost
most of my hearing many years ago, and I've got the RX EQ simulating the
response of my hearing aids [as much as it can], which helps a lot.
73,
Fred K6DGW
- Northern California Contest Club
- CU in the 50th Running of the Cal QSO Party 3-4 Oct 2015
- www.cqp.org
On 9/24/2015 3:09 PM, KC6CNN wrote:
I am looking for someone with more experience than me with using the K3 on
CW.
I have my K3 set to about 75 percent RF gain, and the width set to around
300.
ATT is off and Pre is off I do not have the dual filter on, and no afx on. I
can spot and decode signals if they are strong. If they are weak then I can
only decode with my ears. The THR setting when you hold down the CWT button
is set on 3. If I set to auto is just sits there and runs jumble letters
across the vfo b screen.
Any help with good setting I can try would be appreciated.
Thanks
Gerald - KC6CNN
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
