I have had the K3S, KAT500 and KPA500 connected and configured.
All units are connected to the computer via USB so I can use the
appropriate Utility.
Now, when I try to connect the P3 to the K3S there is this behavior. I
can only use the USB *or* the RJ45 serial. Once I connect to the RJ-45
serial, the USB is disconnected at the K3S and I lose access to the COM
port(s).
I am guessing there is no value to the RJ-45 port once I decide to use
USB, and I should use the USB-DB9 connector to connect the P3 to my PC
for the P3 Utility.
I thought I had seen something where the PC connected through the K3S or
P3 to the otyher, but I can't find that documented so I think it's
recovered childhood memory.
In summary, I expect to connect PC-to-P3 via USB-DB9 and have only the
DC-power and IF-BNC between the K3S and the P3. DO I HAVE THAT CORRECT?
73, Byron
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
