Several days ago I posted the below to the Reflector. After a couple of days of reproducing the below errors, I can safely say that NONE of them are connected to the Synthesizer Upgrade. Since they all happened since the upgrade I made the incorrect assumption that that had something to do with the new problems.

#1- DVK- Cockpit error. M1 and M2 did not have a message recorded in them, so gave incorrect responses when I tried to play those message. Recorded messages in both, all work normally.
#2- No resolution to this yet.
#3- Could not reproduce the error.  May be tied to #5.
#4- This is how the radio is supposed to function. Hit a key that can't execute when you're transmitting, and
the K3 is supposed to stop transmitting and give the errors.
#5- This seems to be an N1MMLogger+ error, but hasn't been confirmed yet. The DSE errors seemed to be created in the K3 by bad input from N1MM+; in any case, the two got out of sync, and the DSE errors
were created.
#6- Diversity was a red herring. I could reproduce the problems whether diversity was on or off. During the contest, problems didn't seem to start until diversity was turned on, but further research shows that diversity
had nothing to with any problems.
#7- Same as #6.

The Synthesizer upgrade didn't have anything to do with the problems I had.

Dennis W1UE
---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
I did the Synthesizer on my K3 a couple of weeks ago. After putting in the synthesizers, I also upgraded to Firmware 5.33, which was the latest at the time (I see that 5.35 was released the day after I did the upgrade). The SYNTH OK messages were seen on the menu, and the configuration was redone as specified in the instructions. I also took care not to lose any washers inside the radio, and to not disturb anything within the radio. Since then, I have had a number of issues with my K3.

#1- DVK doesn't work via N1MM command. VFO B says "DVK Not installed", but I do have one installed. I can also play the messages by pressing the Message key. I checked the config menu, and it says it is installed.
#2- I have heard a number of loud audio "pops" since the above changes.
#3- I have actually lost audio several times with no VFO B errors- audio just stops in the middle of a QSO. #4- During CQWW RTTY, if I was transmitting and pushed a key- say A/B, or Rev- transmitting stops, I get an "Error PTT" followed by an "Error Key" in the VFO B window for a few seconds each, then the radio clears itself. I can then resume transmitting. No audio loss while this is happening. #5- During the contest, N1MM would show the Radio Mode as PSK. The program would keep on transmitting RTTY, and what went into the log was indicated as RTTY, the K3 was working properly in RTTY and indicated it was in Mode D FSK correctly. #6- When I tried to use Diversity reception, the K3 would switch into Diversity mode correctly. After a while, I would get a sudden total audio loss and one of several DSE errors: E015555, E005555, 00C2C2, 003030.
#7- Turning the diversity OFF seemed to decrease the severity of
In all cases, power cycling the radio would clear the error and the audio would be restored.

I've tried reloading firmware, and it reloaded without a problem. Yes, I power cycled the radio immediately after the firmware update was done. I haven't tried downloading the firmware a second time from the web site, and then reloading it into the radio but I suspect that may be the next thing that I try.

At this point, I'm open to suggestions.  Thanks for input!

Dennis W1UE


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com

Reply via email to