I only tuned enough to not be on top of the station. On October 2, 2015 10:40:28 PM EDT, Bob McGraw - K4TAX <[email protected]> wrote: >If I understand this correctly. It seems you set / tuned the ATU for >a >higher frequency, being the 2nd frequency where you listened, then >moved >back down band with out retuning. It would seem then the ATU would be >set for some frequency other than the one you were receiving. Yes, >going to bypass might indeed likely show a higher received signal. > >73 >Bob, K4TAX > >On 10/2/2015 2:00 PM, [email protected] wrote: >> I was playing with my K3S listening to code on 40m. I could clearly >hear the >> signal but it wasn't loud. I spun the dial up a good bit and >listened, >> nothing heard after about a minute so I pressed ATU Tune. The ATU >clicked a >> few times and stopped. I spun back down where I was (somewhere around >> 7.033MHz) and dialed in the signal. Sounded about the same. Just for >grins I >> did a long press ATU Tune (ATU) to BYPASS. The signal immediately >jumped >> over S9 (was around S7 before). That didn't make sense so I repeated >the >> process a few times with the same results. >> >> >> >> Am I wrong to expect a higher signal level with the ATU tuned than >bypassed? > > >______________________________________________________________ >Elecraft mailing list >Home: http://mailman.qth.net/mailman/listinfo/elecraft >Help: http://mailman.qth.net/mmfaq.htm >Post: mailto:[email protected] > >This list hosted by: http://www.qsl.net >Please help support this email list: http://www.qsl.net/donate.html >Message delivered to [email protected]
-- Sent from my Android device with K-9 Mail. Please excuse my brevity. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
