Thanks Dick, Looks like I could either have the KPA500 sniff the RS-232 line into the KAT500 (use RXD pin only at the KPA500), or implement BAND0-3 and make it minimally emulate a K3S into the KPA500.
73, Cliff K3LL -----Original Message----- From: Dick Dievendorff [mailto:d...@elecraft.com] Sent: Friday, October 09, 2015 10:55 AM To: Cliff Frescura Cc: elecraft@mailman.qth.net Subject: Re: [Elecraft] [KAT500] PC Data to Amp Control? The KAT500 can read, but not pull down the 4 band change lines. Dick, K6KR Sent from my iPhone > On Oct 8, 2015, at 21:07, Cliff Frescura <c...@cfcorp.com> wrote: > > Hi, > > > > If I change bands on the KAT500 via the PC Data port, it appears that > the new band data is not sent to the Amp Control connector. Is this > expected behavior? (hoping no). > > > > For reference, my setup is: > > > > Kenwood TS-940 > > DXLabs Logging program > > KAT500 > > KPA500 > > > > The 940 is connected to the computer and controlled by DXLabs. DXLabs > is configured to send commands to the KAT500 (follow the 940). This > all works fine. I'm now trying to have the KPA500 follow the KAT500 > via the Amp Control connector on the KAT500 (with E850463 cable). > > > > 73, > > > > Cliff K3LL > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net Please help support this email > list: http://www.qsl.net/donate.html Message delivered to > d...@elecraft.com ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com
