I had a very similar experience working in the California QSO
Party. I don't think the contest logger was part of the problem
since I had problems with my USB hub and most of the time the
logger couldn't see the K3.
73 Bill AE6JV
On 10/12/15 at 10:51 AM, [email protected] (Ron W3ZV) wrote:
Trying to figure out a problem. I spent this weekend on the PA
QSO Party. I use the K3 DVR for CQ, MyCall and QSL, TU, QRZ
messages, activated by N1MM macros. When things slowed down I
used repeat CQ. I have a serial port activating PTT with canned
messages and my footswitch for live mic. This is my first
outing with this setup. I had previously used PTT via CAT
control for canned messages.
My problem is that when I activated my foot switch close to the
time the repeat CQ was scheduled, I was interrupted by the CQ
message when I began to talk. If the repeat CQ was not
imminent, no problem
I don't know if this was a PTT race condition, or a software problem with the
contest logger.
Any insight would be appreciated.
-------------------------------------------------------------------------
Bill Frantz | Re: Hardware Management Modes: | Periwinkle
(408)356-8506 | If there's a mode, there's a | 16345
Englewood Ave
www.pwpconsult.com | failure mode. - Jerry Leichter | Los Gatos,
CA 95032
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
