Hi Byron, If you have the BNC connector then it seems logical that you choose BNC when setting up the KRX3. From there the solution is quite simple. Just be sure when activating the Sub RX that the word MAIN comes up in the lower display. This tells you that the Sub RX is using the same antenna as your Main RX. If the work AUX comes up then just long hold the RX ANT button and you'll see the work MAIN come up.
73, Mike K2MK Byron Peebles wrote > It's unclear to me what the setting for KRX3 should be. > > 1. I do have the KRX3A installed. > 2. I do NOT have an antenna on the BNC, nor on ANT2.. > 3. I have a SINGLE SIGNAL PATH from antenna to K3S on ANT1. > > When I set KRX3 to KAT3, I believe it changes the sub antenna to K3S ANT2. > This follows the description of using a separate "receive antenna path". > But since I don't have a second path, I change it back to ANT1. > > Is this wrong? Is there no reason to have a KRX3A if you don't have a > dedicated receive antenna? > > 73, Byron -- View this message in context: http://elecraft.365791.n2.nabble.com/K3S-Config-Sub-Receiver-Signal-Path-without-BNC-Antenna-tp7609242p7609243.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
