All,
I found the problem. My serial cable had a broken wire on pin
2. I had used the serial cable on my KPA-500 and it was working. Must
have broken when I removed it from the system and used it to test the
KRC2. Thanks for all the pointers and help! Murphy is so busy at my QTH,
hope he leaves soon!
Thank you,
Gordon - N1MGO
On 10/25/2015 08:54 AM, Don Wilhelm wrote:
John,
Actually a standard serial cable can be connected to the KRC2 if
jumpers W11 thru W20 are removed, no need to cut off wires in the cable.
That information *is* in the plugging configuration charts.
73,
Don W3FPR
On 10/25/2015 8:43 AM, John K9UWA wrote:
A simple statement in the KRC2 manual could have been added by Elecraft
stating. To Program your KRC2 to your K3 radio get a standard DB9 serial
cable. and CUT OFF all wires EXCEPT 2, 3 and 5. Mark the cable Program
KCR2 ONLY and save the cable for future use. I wonder how many
additional KRC2 boxes Elecraft could have sold over the last 4 years?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
--
Gordon - N1MGO
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
